Braze Alloys
Palsil® 10 Technical Information
High-purity silver and palladium alloy for vacuum brazing
Key Benefits
- Good on Ni, SS, Mo and short brazing on Ti
Typical Applications
- Aero-engines (OEM and repair)
- Aerospace fuel-line assemblies
- Vacuum tubes
- Wave guide and Klystron assemblies
- Power supply surge arrestors
- Automotive components
Nominal Composition by Weight
- Silver (Ag): 90%
- Palladium (Pd): 10%
Suggested Base Materials
- Carbon/low alloy & Tool/high speed steel
- Stainless steel
- Ni-super alloys
- Titanium
- Refractory
Forms Available
If the form you require is not listed contact us today|
Palsil® 10 Thermal Properties |
||
|---|---|---|
|
°C |
°F |
|
|
Liquidus |
1070 |
1958 |
|
Solidus |
1025 |
1877 |
|
Palsil® 10 Physical Properties* |
||||
|---|---|---|---|---|
|
Metric |
Imperial |
|||
|
Thermal Conductivity (Calculated) |
108 |
W/(m*K) |
62.4 |
BTU/ft h °F |
|
Density |
10.6 |
Mg/m3 |
0.382 |
lb/in3 |
|
Yield Strength (0.2% offset) |
95 |
MPa |
13.7 |
x103 lb/in2 |
|
Tensile Strength |
205 |
MPa |
29.7 |
x103 lb/in2 |
|
Elongation (2in/50mm gage section) |
40 |
% |
||
|
Electrical Resistivity |
70 |
x10-9(ohm*m) |
||
|
Electrical Conductivity |
14 |
x106/(ohm*m) |
||
|
Recommended Brazing Atmospheres |
10-5 mm Hg or inert gas |
|||
* Please note that all values quoted are based on test pieces and may vary according to component design. These values are not guaranteed in any way and should only be treated as indicative values. They should be used for guidance only and for no other purpose whatsoever.